94 lines
2.6 KiB
C
94 lines
2.6 KiB
C
#ifndef ONEWIRE_H_
|
|
#define ONEWIRE_H_
|
|
|
|
#ifdef __cplusplus
|
|
extern "C" {
|
|
#endif
|
|
|
|
#include <stdint.h>
|
|
|
|
/*******************************************/
|
|
/* Hardware connection */
|
|
/*******************************************/
|
|
|
|
/* Define OW_ONE_BUS if only one 1-Wire-Bus is used
|
|
in the application -> shorter code.
|
|
If not defined make sure to call ow_set_bus() before using
|
|
a bus. Runtime bus-select increases code size by around 300
|
|
bytes so use OW_ONE_BUS if possible */
|
|
// #define OW_ONE_BUS
|
|
|
|
#ifdef OW_ONE_BUS
|
|
|
|
#define OW_PIN PD6
|
|
#define OW_IN PIND
|
|
#define OW_OUT PORTD
|
|
#define OW_DDR DDRD
|
|
#define OW_CONF_DELAYOFFSET 0
|
|
|
|
#else
|
|
#if ( F_CPU < 1843200 )
|
|
#warning | Experimental multi-bus-mode is not tested for
|
|
#warning | frequencies below 1,84MHz. Use OW_ONE_WIRE or
|
|
#warning | faster clock-source (i.e. internal 2MHz R/C-Osc.).
|
|
#endif
|
|
#define OW_CONF_CYCLESPERACCESS 13
|
|
#define OW_CONF_DELAYOFFSET ( (uint16_t)( ((OW_CONF_CYCLESPERACCESS) * 1000000L) / F_CPU ) )
|
|
#endif
|
|
|
|
// Recovery time (T_Rec) minimum 1usec - increase for long lines
|
|
// 5 usecs is a value give in some Maxim AppNotes
|
|
// 30u secs seem to be reliable for longer lines
|
|
//#define OW_RECOVERY_TIME 5 /* usec */
|
|
//#define OW_RECOVERY_TIME 300 /* usec */
|
|
#define OW_RECOVERY_TIME 10 /* usec */
|
|
|
|
// Use AVR's internal pull-up resistor instead of external 4,7k resistor.
|
|
// Based on information from Sascha Schade. Experimental but worked in tests
|
|
// with one DS18B20 and one DS18S20 on a rather short bus (60cm), where both
|
|
// sensores have been parasite-powered.
|
|
#define OW_USE_INTERNAL_PULLUP 1 /* 0=external, 1=internal */
|
|
|
|
/*******************************************/
|
|
|
|
|
|
#define OW_MATCH_ROM 0x55
|
|
#define OW_SKIP_ROM 0xCC
|
|
#define OW_SEARCH_ROM 0xF0
|
|
|
|
#define OW_SEARCH_FIRST 0xFF // start new search
|
|
#define OW_PRESENCE_ERR 0xFF
|
|
#define OW_DATA_ERR 0xFE
|
|
#define OW_LAST_DEVICE 0x00 // last device found
|
|
|
|
// rom-code size including CRC
|
|
#define OW_ROMCODE_SIZE 8
|
|
|
|
extern uint8_t ow_reset(void);
|
|
|
|
extern uint8_t ow_bit_io( uint8_t b );
|
|
extern uint8_t ow_byte_wr( uint8_t b );
|
|
extern uint8_t ow_byte_rd( void );
|
|
|
|
extern uint8_t ow_rom_search( uint8_t diff, uint8_t *id );
|
|
|
|
extern void ow_command( uint8_t command, uint8_t *id );
|
|
extern void ow_command_with_parasite_enable( uint8_t command, uint8_t *id );
|
|
|
|
extern void ow_parasite_enable( void );
|
|
extern void ow_parasite_disable( void );
|
|
extern uint8_t ow_input_pin_state( void );
|
|
|
|
#ifndef OW_ONE_BUS
|
|
extern void ow_set_bus( volatile uint8_t* in,
|
|
volatile uint8_t* out,
|
|
volatile uint8_t* ddr,
|
|
uint8_t pin );
|
|
#endif
|
|
|
|
#ifdef __cplusplus
|
|
}
|
|
#endif
|
|
|
|
#endif
|